Operating Guide
Connect the BoardShare camera to your computer using the USB cable.

Launch the BoardShare application from your desktop. Follow the prompts to start the calibration process.

Position the BoardShare camera at a distance D= W+H from the display area, where W is the width and H is the height of the display area. Place the camera about one foot behind the projector.

Tilt the BoardShare camera arm until the laser light is pointing near the center of the red calibration circle. Use the pen to select the 9 calibration points.

You are ready to use BoardShare; remember to always select the “pen“ from the palette in order to write; Select the “pointer” to navigate through your PC screen.

Hold the pen as shown so as not to block the IR communication between the pen and the camera. Always start writing slowly with the pen front flat on the screen until you get used to the pen.
